Denali CANsmart™ Controller GEN II - KTM 1290, 1190, 1090, 1050, & 790 Series

Take control of your KTM motorcycle's CAN bus electrical system with the upgraded DENALI CANsmart™ Controller GEN II. Engineered specifically for KTM 1290, 1190, 1090, 1050, & 790 series motorcycles, this smart controller brings a new level of flexibility and intelligence to your motorcycle's electrical system, making accessory installations a breeze.

The DENALI CANsmart™ Controller offers plug-n-play installation and integrated control of up to four accessories. This allows you to harness dozens of customizable settings that can be controlled directly from your KTM's existing handlebar switches, the optional KTM CANsmart Control Switch, or the CANsmart™ Accessory Manager Software.

The CANsmart's four circuits are preset to connect and independently control two sets of DENALI lights, a SoundBomb horn, and our B6 auxiliary brake light.

Gen II - More Features, More Power, More Versatile The GEN II version provides a full 10 amps of continuous power across all four circuits, and each circuit can be configured to run any accessory type. The entire unit can handle a maximum power draw of 30 amps continuously. The Gen II also introduces two new auxiliary light settings - modulation of your auxiliary lights for added conspicuity, and independent cancellation of left and right side lights when the corresponding turn signal is activated.

Features:

• KTM Dongle Functionality: Enables additional features in the ABS control unit and the ECU and remembers settings to prevent the need to reset the ABS and MTC with every restart. Also activates the 80 octane "Bad Fuel" function, reducing engine power for lower fuel quality trips.
• High/Low Sync: Programmable settings for auxiliary lights using the factory high beam switch.
• ON/OFF and Dim: Independently control two sets of lights ON/OFF and brightness right from your bike's switches or via the software/optional control switch.
• Modulate Lights: Enhance your visibility to other motorists with modulating auxiliary lights.
• Flash to Pass: Draw attention by pulsing your high beam switch thrice to strobe your auxiliary lights.
• Cancel With Turn Signal: Prevent your powerful auxiliary lights from overpowering your signal by cancelling the corresponding light when the turn signal is on.
• Inverse Flashing With Hazards: Increases visibility during roadside emergencies by flashing your auxiliary lights inversely to your hazard lights.
• Plug & Play Horn Installation: Connect high power aftermarket horns like our SoundBomb™ easily without needing an extra harness or relay.
• Deceleration Activated "Smart Brake" Technology: The CANsmart™ reads vehicle speed to activate your auxiliary brake light during deceleration before you even touch the brake.
• Circuit Function Selector: Select any accessory to run on any of the four circuits with the Circuit Function Selector in the CANsmart software.
• Switched Power Source: Clean switched 12V power that turns on and off with your ignition.
• Delay Time Out: Set your accessories to stay powered up to 30 seconds after you turn off your bike.
• On Board Power: Ideal for powering your GPS, phone, heated gear, or any other electronic device.

Embrace the smart control provided by the DENALI CANsmart™ Controller GEN II - KTM 1290, 1190, 1090, 1050, & 790 Series, and enjoy an optimized riding experience. Order now!